Focus on water soluble film application 

How to solve the problem of oiliness and static electricity on the release surface of PET release film? -Film supplier

by:POLYVA     2021-12-04
1. It cannot be peeled off after being pasted with the tape, which is generally the cause of uneven coating. Some PET release film missed more serious will make a certain part of the release effect, resulting in the tape cannot be peeled off, die cutting with a round knife This question should be taboo. 2. The oily PET release surface is mainly caused by the release agent system. It is not that greasy things must be bad. In fact, the surface of some greasy release films is coated more uniformly and the residual adhesion rate is better. But some are simply because of poor adhesion, and silicone oil is easy to fall off. These can also be determined by testing. 3. Static electricity problems, in addition to physical treatment methods, chemical treatments are generally permanent. Generally, photoelectric die-cutting plants have dust-free workshops and equipment for removing static electricity. The problem will not be very big. . For more stringent requirements, you can choose antistatic coated PET release film. 4. Noise occurs during peeling, one is the excessive release force, and the second is the result of uneven coating. There are many ways to judge whether coating is not available. One of the simpler is to look at the surface of the film against the light in the sun, and the surface coating effect of the film can be seen at a glance. For example, on the surface of a release film produced in South Korea, spots of coating marks can be seen on the surface, and there is an imagination of rainbow. Everyone can go and take a look. 5. The anti-peeling is mainly caused by the unsatisfactory matching of the release force. There are two reasons. First, the release film is not strictly inspected at the factory, the inspection equipment is incomplete, and the production process is not stable enough, which makes the product of the same model release force. Too much difference. As a result, the die-cutting factory used the release film with the release force they thought out of the habit of use. Second, the weather resistance of the release layer is not enough, and huge changes have taken place over time. It is a company specializing in the production of PET film with multiple functions, such as: transparent PET film, milky white PET film, release PET film, supply of PET motor film, etc. With a wide variety of products, affordable prices, and environmental protection, we provide customers with excellent quality and service based on the service tenet of excellence in production, honesty and trustworthiness in distribution, and warm and thoughtful service. Interested parties welcome to inquire!
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...