What should I do if I encounter film breakage and wrinkles during PET film printing? -Film supplier

What should I do if I encounter film breakage and wrinkles during PET film printing? Film breakage refers to the sudden breakage of the original film during rotary printing. Reasons: 1. The end of the original membrane is damaged or notched. 2. There is a hole in the middle of the original membrane. 3. The joint is not completed. 4. Uneven tension (too large). The air pressure of the unit impression cylinder is inconsistent. Solutions: 1. Carefully check whether the end surface of the original film is in good condition before winding. If it is damaged, it should be removed or replaced. 2. Re-thread the film after the film is broken. If there are two holes in the same roll, replace the original film. The defective original film shall be returned to the warehouse. 3. Strengthen technical training of personnel 4. Appropriate adjustment (reduction) of tension 5. Ask the maintenance department to repair the impression cylinder cylinder of the unit, and adjust the air pressure to make the air pressure on both sides of the cylinder consistent. It is a company specializing in the production of PET film with multiple functions, such as: transparent PET film, milky white PET film, release PET film, supply of PET motor film, etc. With a wide variety of products, affordable prices, and environmental protection, we provide customers with excellent quality and service based on the service tenet of excellence in production, honesty and trustworthiness in distribution, and warm and thoughtful service. Interested parties welcome to inquire! Contact: Wen Feng 13728425799