Pay attention to PET film printing and dry lamination: 1. Use as little ink as possible, and the ink should be dry (dry) to prevent false drying of the ink (especially when printing with chlorinated polypropylene composite plastic ink) . If the printing speed of the printer cannot be turned on, and the effect of the drying box is poor, you can rewind the printed matter once, and blow air or leave it for some time during rewinding, and wait for the ink to harden before recombining. It is best to rewind and blow air to prevent the printing film from sticking). 2. The amount of glue applied during the compounding must be small, and the solvent of the compound glue must be evaporated as much as possible when passing through the drying tunnel (check whether the exhaust system of the drying tunnel is unblocked, and the compound hot drum temperature of the compound machine should not be lower than 70 ℃. Is a company specializing in the production of PET film with multiple functions, such as: transparent PET film, milky white PET film, release PET film, supply of PET motor film, etc.. There are a wide range of products, affordable, technological and environmentally friendly. We strive for excellence in production and honesty in distribution The service tenet of trustworthiness, warm and thoughtful service and the spirit of assisting partners to achieve their own careers and to provide customers with excellent quality and service. Interested parties welcome to inquire!